Skip to main content
Skip table of contents

Adding Salt Targets & Ranges

There are 3 places that you can set Salt Targets & Ranges.

  1. On the Targets & Ranges page - either in the default settings for all pools/spas/water features or if the Structure in question has special settings associated with it because it has a particular wall finish, is a particular Pool Type or has a particular Sanitiser method etc

You can access this popup by clicking on the Structure heading or clicking on the New Structure button

This will be shown on the Structure’s Water Test settings..

2. The second way to change the Salt Targets & Ranges is on the Salt Chlorinators page

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close